TS100(M8N) Introduction
RadioLink M8N GPS TS100 benefits from 22+ years of professional wireless experience of RadioLink engineers, exceeding the limitation of IC sensitivity index from circuit schematic design to PCB placement.
50 centimeters of position accuracy. Positioning 20 satellites in 6 seconds at open ground. Industry-leading valley station-keeping ability.
TS100(M8N) is compatible with the flight controller RadioLink PIX6, CrossFlight-CE, CrossFlight, F405, F722, CrossRace Pro, CrossRace, Mini Pix, and PIXHAWK (the multi-copter/helicopter firmware after V3.5.4 version, the fixed-wing firmware after V3.8.0 version). Other flight controllers are also compatible with TS100(M8N).
TS100(M8N) Configuration
GPS decoder chip: Radiolink M8N GPS, with u-blox UBX-M8030(M8), 72-channel, is much better than a single GNSS 7N.
Built-in electronic compass VCM5883L.
Antenna: 2.5dbI high-gain and selectivity ceramic chip antennas.
Double Filter: SAWF (Surface acoustic wave filter) from Murata.
50 centimeters of positioning accuracy.
Positioning 20 satellites in 6 seconds at open ground.
Super positioning capability even at the valley bottom.
Support multiple positioning systems, GPS, GLONASS L10F, QZSS L1 C/A, BeiDou B1; dual-mode operation is available.
Dual-frequency: 1575±1MHz、1602～1610MHz.
Parameter
Positional Accuracy: Up to 50 centimeters with Dual Modes/250 centimeters with Single Mode
Protocol: Default NMEA
But when connecting the TS100(M8N) to the flight controller, it will recognize the type of flight controller and turn the protocol to the same protocol as the flight controller automatically. When the TS100(M8N) disconnects from the flight controller, the protocol will turn back to the default NMEA.
Velocity precision: 0.1m/s
Max height: 50000m
Max speed: 515m/s
Max acceleration: 4G
Max update rate: 10Hz
Sensitivity: Tracking & Nav.：-167dBm
Acquisition：-163dBm
Cold start：-151dBm
Hot start：-159dBm
Activation Period: Cold start: 26s
Hot start: 1s
Power supply: Voltage: 5±5% VDC
Current: 50~55mA
Ports:
GPS: UART port with baud rate 9.6K
Geomagnetic: I2C port
Baud rate: 9.6K
Definition of Connector
Connect to flight controller: Black wire-GND, Yellow wire-SDA, Green wire-SCL, Blue wire-RX, White wire-TX, Red wire-VCC
GPS Mainboard: White wire-RX, Blue wire-TX, Red wire-VCC, Black wire-GND, Green wire-SCL, Yellow wire-SDA
TS100(M8N) Connect to Mini Pix
Positioning Indicate
Humanized positioning green LED indicates. The green LED will flicker when the TS100(M8N) has achieved positioning.
Compass Calibrate
Please use Mission Planner
Arrows show the front, pointing in the same direction as the flight controller.
Keep the same direction as the flight controller.
Compass calibration (using version 1.3.39 of Mission Planner), please choose Pixhawk/PX4 if you use it with the flight controller MINI PIX or PX4.
Calibrate like this picture shows, and click Done to finish the calibration. Click OK to save the settings.
Calibrate like this picture, click Done to finish the calibration. Click OK to save the settings.
If 
please try to cancel Compass #1 or Compass #2.
